General International 25-036, Setup & Operation Manual

Page: 6 / 20

ASSEMBLING THE CLAMPING PLATE HARDWARE
1. Lay one clamping plate A on a flat surface with the flat
side down
.
2. Thread one 12 mm set screw B into the threaded hole
in the clamping plate until it is flush with the flat surface.
3. Thread a M12 nut C onto the set screw until it touches
the clamping plate.
4. Using the 6 mm allen wrench, hold the set screw while
tightening the nut with the supplied 19 mm wrench as
shown.
5. Do this for both of the clamping plates.
A
B
C
ASSEMBLING THE CLAMPING PLATES TO THE SUPPORT BEAMS
1. Fit the set screws on the clamping plates into the slot
D on the support beams and secure them to the
beams with a 12 x P26 washer E and M12 hex nut F ,
leaving them loose for now G .
Note: If your wood lathe swing diameter is 12”, then DO
NOT install the alignment bolt
G
on the support beams.
2. For lathes with a swing of 14” or more, install a 12
mm x 65 mm long alignment bolt
H and thread into
each support beam until it is flush with the other si-
de of the hole.
ASSEMBLING & INSTALLING THE DUPLICATOR ON A WOOD LATHE
TEMPLATE CLAMPING BRACKET ASSEMBLIES
1. Assemble the clamping bracket components A as shown in B . and set them aside for now.
A B
6
H
H
On lathes that have a swing of 14” or more:
Bolt
H
is used as an alignment stop to set the duplica-
tor parallel to the bed ways. It makes it much quicker
when re-mounting the duplicator by pre-setting the posi-
tion the duplicator was in before you removed it.
D
G
I
E
F