10
INSTALLING THE SLIDE HANDLE
1.
Screw the threaded end of the slide handle,
A
, into
the hole in either the top left
B
or right
C
of the fix-
ing block until it stops at the nut.
2.
Tighten down the nut
D
to secure the handle to
the block.
C
D
B
INSTALLING THE HANDWHEEL
1.
Fit the handwheel hub onto the end of the shaft tak-
ing care to line up the bolt
A
with the hole in the
shaft
B
as shown.
2.
Secure the handwheel to the shaft by tightening
the bolt using the supplied 10 mm wrench.
ATTACHING THE FOLLOWER ARM WITH STYLUS TO THE CARRIAGE ASSEMBLY
A
C
C
1.
Insert the stylus end of the follower arm into the
hole,
A
until it stops at the snap ring
B
.
2.
Tighten the bolt
C
using the supplied 12 mm open
end wrench.
A
ATTACHING THE CHIP GUARD
The chip guard will keep debris from getting onto the
duplicator and possibly hindering smooth movement of
the carriage assembly.
1.
Slip the hole in the guard over the cutting tool arbor
until it is past the set screw as shown.
The built in pressure ring on the guard holds it in place. A
slight rotating action while sliding the guard forward or
backwards on the arbor shaft will aid in repositioning.
B
B
A
Summary of Contents for 25-036
Page 19: ...Notes 19 ...
