ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person for help with lifting
• Phillips Screwdriver
• Utility knife
• Flat piece of wood or any similar non-cutting object
ASSEMBLY INSTRUCTIONS
INSTALL THE CARRYING HANDLES
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE
COMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
INSTRUCTED TO DO SO.
Install the carrying handles
A
on both sides of the
sander using 2 cap screws
B
and tighten with the sup-
plied 6 mm T-handle allen wrench.
Note: Do not lift the sander by the conveyor table.
Always use the carrying handles to lift or carry the
sander.
INSTALL THE CONVEYOR HEIGHT ADJUSTMENT HAND WHEEL
1.
Screw the handle
C
into the threaded hole in the
hand wheel.
2.
Install the conveyor table height adjustment hand
wheel onto the shaft located on the top left end
of the sander
B
. The slots in the hand wheel must
be aligned with the spring pin on the shaft
A
.
A
B
C
B
A
ASSEMBLE THE STAND
Note: If the sander is to be used without our supplied
stand, then the following instructions do not apply –
please skip ahead to the next section on page 10.
1.
With the 16 shoulder bolts, washers, lock washers
and hex nuts,
A
, begin assembling one end of the
sander stand by attaching 1 short top shelf and
1 short cross brace to 2 legs,
B
.
Note: Do not tighten hex nuts until all fasteners are
atta-ched. Then place the stand on a flat surface to
square it up and finally tighten all the nuts.
2.
Assemble the opposite side of the stand the same
way as described in step 1. Then use the 2 long top
shelves and 2 long cross braces to join both
assembled ends and complete the stand as
shown in
C
on next page.
9
Short top shelf
Legs
Short cross brace
(Be sure to attach all
horizontal shelves and
cross braces to the insides
of stand legs.)
A
B