7
INSTALLATION
NOTE
Do not block the vents or place anything on top
of your SB3100Di.
ACT
LINK
ENET
CABLE
POWER
Ethernet to
com p uter
Telephone
cable to
phone jack
TV cable to
cable outlet
Power cord
to electrical
outlet
You must call your service provider to activate your service. You need to
provide the media access control (MAC) address. This address is found on
the barcode label marked HFC MAC ID on the rear panel. The address
format is 00:20:40:xx:xx:xx.
The installation of the SB3100Di can be completed in a matter of minutes.
After you attach the four cables, you must configure your computer. Basic
instructions are provided on page 10.
For a Single User
1
Connect the coaxial TV cable to the SB3100Di connector marked
CABLE and the other end to the cable outlet or splitter. Hand-tighten
the connectors to avoid damaging them. You may need a 5-900 MHz
splitter if you have a TV connected to the cable outlet.
2
Connect the telephone cable to the SB3100Di connector marked with
the phone icon and the other end to the phone jack.
3
Connect the 10Base-T Ethernet cable to the SB3100Di connector
marked ENET and the other end to the Ethernet jack on the back of
your computer.
4
Plug the power cord into the SB3100Di connector marked POWER
and the other end to the electrical outlet.
