background image

Step 4

Place pump at the bottom of the

reservoir. Lower lid so that the Pump

Outlet Manifold and power cord fit

through hold in reservoir lid as shown.

Page 4

Page 5

Step 5

Line the inside of the chamber grommet with a thin coating of silicon

grease (optional). Insert the Drain Level Tube half way into the grommet.

The overflow tubes are adjustable allowing for greater flexibility in water

height. Repeat this step for the other 5 chambers.

Step 6

Assemble Snapstand (see inclosed instructions). Arrange the Growing

Chambers on top of reservoir with the other end resting on the

Snapstand. Center the Growing Chambers Drain Fittings over the

Step 7

Screw the flexible Chamber

Manifold onto the Pump Line.

Drain/Overflow hole

Step 8

Attach Chamber

Manifold to Chamber

Spray Lines by tighten-

ing the thread connec-

tions. Start from one

end and work across.

Summary of Contents for AeroFlo2 36

Page 1: ...ould I adjust the overflow tubes up or down When plants are small and their roots are not well developed the overflow tubes should be at the maximum height to allow nutrient rich water to reach the bottoms of the net cups Once the roots have grown in length and are immersed within the flowing stream of nutrient the overflow tubes can be pushed down to increase oxygen within the nutrient and growin...

Page 2: ...Hydroponics offers a wide variety of plant foods We have had great success using our Flora series 3 part system FloraGro FloraBloom and FloraMicro 1 Fill the reservoir with fresh water If you are in an area with poor quality water over 200 ppm Total Dissolved Solids we recommend that you use purified water Reverse Osmosis and or rain water General Hydroponics also has Hardwater FloraMicro nutrient...

Page 3: ...ervoir capacity is 40 gallons This means that the total system capacity is approximately 54 gallons in the flooded stage overflow tubes set high and 42 gallons in the low stage overflow tubes pressed to the bottom Fill the reservoir with water Turn on the pump The pump will drive water into the growing chambers Note It may be necessary to adjust the angle of the Laser Spraylines so that they are s...

Page 4: ...low tubes are adjustable allowing for greater flexibility in water height Repeat this step for the other 5 chambers Step 6 Assemble Snapstand see inclosed instructions Arrange the Growing Chambers on top of reservoir with the other end resting on the Snapstand Center the Growing Chambers Drain Fittings over the Step 7 Screw the flexible Chamber Manifold onto the Pump Line Drain Overflow hole Step ...

Reviews: