General DataComm PacketMate 1000, User Manual

Page: 15 / 20

ACT Status Description LNK Status Description
Orange 10/100 LAN Yellow Linked
Green GbE LAN Off Unlinked
Connections using rear panel Ethernet ports:
Connect the RJ-45 patch cable to the PacketMate?s Ethernet port. 1.
Connect the opposite end of the patch cable to another network device (router, switch, server,
computer, etc.) through its Ethernet port. 2.
Connections using optional cards: WAN Cards
Connect the RJ-48 patch cable to the WAN port.
With T1, if connecting directly to another T1 interface, a T1 cross over cable is needed. 1.
With DS3/E3, connect the Tx on the optional card to the Rx on the network device and the Rx
on the optional card, to the Tx on the network device.. 2.
1.
Connect the opposite end of the patch cable to another network device. 2.
Serial WAN Cards
Connect the DB-9 patch cable to the WAN port.
With T1, if connecting directly to another T1 interface, a T1 cross over cable is needed. 1.
With DS3/E3, connect the Tx on the optional card to the Rx on the network device and the Rx
on the optional card, to the Tx on the network device.. 2.
1.
Connect the opposite end of the patch cable to another network device. 2.
Chapter 3: Operations Information
Open the Chassis:
To remove the top lid, loosen the 4 screws on the chassis. Two on either side of the chassis. 1.
Remove the top lid from the base. 2.
001
Router Connections 11