General DataComm 060A027-001, Installation & Operation Manual

Page: 87 / 138

AT Command Set Operation AT Command Reference Tables
060R122-000 SpectraComm Dual V.34 Modem 4-7
Issue 15 Installation and Operation
&G n
DCE rate limit Sets the maximum rate for the modem to make a VF connection to a remote modem.
The allowable rates are: 2.4 to 28.8 kbps for V.34, 4.8 or 9.6 kbps for V.32 only, and
4.8 to 14.4 kbps for V.32
bis only.
If you set a rate that is outside the range of rates available for the modulation in use,
the modem will use the closest available rate.
&G5
4.8 kbps, maximum rate
&G6
7.2 kbps, maximum rate
&G7 9.6 kbps, maximum rate
&G8
12 kbps, maximum rate
&G9 14.4 kbps, maximum rate
&G10
16.8 kbps, maximum rate
&G11
19.2 kbps, maximum rate
&G12
21.6 kbps, maximum rate
&G13 24 kbps, maximum rate
&G14
26.4 kbps, maximum rate
&G15 28.8 kbps, maximum rate
&G16
31.2 kbps, maximum rate
&G17
33.6 kbps, maximum rate (DEFAULT)
\G n
Modem-to-modem flow
control Provides modem-to-modem flow control for non-error corrected data links that
require a constant speed DTE interface (Wire Mode).
\G0
Disables flow control between the two modems.
\G1
Enables bidirectional modem flow control based on XON/XOFF signaling. The XON/
XOFF signals are detected, acted on, and deleted from the data stream.
\G2 Provides unidirectional flow control: the modem may send XON/XOFF signals to the
remote modem, yet ignore and pass through to its DTE any that it receives as VF
signals.
\G3
Same as
\G1
, except after they are acted upon, XON/XOFF signals are passed
through to the DTE instead of being deleted.
H n
Hookswitch Controls the off-hook relay. This command is not affected by factory defaults.
H0 Opens the relay for on-hook condition (modem hang-up).
H1
Closes the relay for off-hook condition. Modem remains off-hook until termination of
on-line status, or until the
H0
command is issued.