Operation
Owner’s Manual for 60 Hz Air-Cooled Generators
17
Menu System Navigation
Use the ESCAPE button from any page to get to the MENU. Press the ESCAPE button several times before reaching
the MENU page if needed. Navigate to the desired menu by using the
↑
/
↓
buttons. Press the ENTER button when the
desired menu is displayed and flashing.
Figure 3-8. Navigation Menu
EVOLUTION 2.0 / SYNC 3.0 HSB MENU MAP
Switched to “OFF”
Hours of Protection
0 (H)
Note: Menu functions and features may vary
depending on unit model and firmware revision.
* Hours of Protection and
number of hours will flash
every 5 seconds when
displayed.
*
Ready to Run
Hours of Protection
0 (H)
Utility Loss Delay
Pausing for 13 sec.
Cranking
Attempt # 3
Running in Exercise
Hours of Protection
0 (H)
Running
Cooling Down
Running - W
arning
“W
arning Message”
W
arning Message(s)
Low Battery
Exercise Set Error
Service Schedule
A
Service Schedule B
Inspect Battery
Stopping...
FIRMW
ARE ERROR-9
Fuel Pressure
Battery Problem
Charger W
arning
Charger Missing
AC
Overload W
arning
SEEPROM ABUSE
USB W
arning
Download Failure
Overload W
arning
No WIFI Module
No WIFI Router Comms
No WIFI Server Comms
Cranking - W
arning
“W
arning Message”
Alarm Message(s)
High Engine
T
emp
Low Oil Pressure
Overcrank
Overspeed
RPM Sense Loss
Underspeed
Controller Fault
FIRMW
ARE ERROR-7
WIRING ERROR
Overvoltage
Undervoltage
Overload Remove Load
Low V
olts Remove Load
Stepper Overcurrent
Auxiliary Shutdown
Emergency Stop
Fuse Problem
Loss of Speed Signal
Loss of Serial Link
Stopped - W
arning
“W
arning Message”
Cranking
Pausing for 13 sec
Running
Hours of Protection
0 (H)
Running
W
arming Up
Running -
Alarm
“Alarm Message”
Cranking -
Alarm
“Alarm Message”
Switched OFF
Hours of Protection
0 (H)
UP
ARROW
=
+
DOWN ARROW
=
-
006667
006667
Summary of Contents for G0071411
Page 41: ......