Generac Portable Products 1295-0, Owner'S Manual

Page: 11 / 24

11
Generac Portable Products 3200PSI High Pressure Washer
• To start a cold engine, move the choke lever to
the “CLOSED” position. To restart a warm
engine, leave the choke lever in the “OPEN”
position (Figure 11).
• Set the engine switch to the “ON” position
(Figure 12).
• Grasp starter grip and pull slowly until you feel
some resistance. Then pull cord out with rapid full
arm stroke. Let rope return slowly. Do not let rope
“snap back” against starter.
• If the choke lever has been moved to the
“CLOSED” position to start the engine, gradually
move it to the “OPEN” position as the engine
warms up.
How to Stop Your Pressure Washer
• Move the throttle lever to the “ Slow ” position.
• Wait for the engine to idle down.
• Move the engine switch to the “
OFF ” position.
• Simply shutting off the engine will not release
pressure in the system. Squeeze trigger on the
spray gun to relieve pressure in the hose.
Note: A small amount of water will squirt out when
you release the pressure.
How to Use the Nozzles
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-270-1408 .
DANGER
! Never exchange nozzles without
locking the safety latch on the trigger.
The quick–connect on the nozzle extension allows
you to switch between five different nozzles. The
nozzles vary the spray pattern as shown below
(Figure 13).
Figure 13 — Nozzles
White
40°
Green
25°
Black
65°
Yellow
15°
Red
0°
Low
Pressure Use
to apply
chemical
Figure 12 — Engine Switch
Figure 11 — Choke Positions
Choke Lever
Closed
Open
Off
Engine Switch
On