Generac Portable Products 10000EXL, Owner'S Manual

Page: 4 / 24

Generac Portable Products 10,000EXL Generator
4
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result in
an engine failure.
TO REMOVE GENERATOR
FROM CARTON
• Set the palleted carton on a rigid flat surface.
• Carefully cut bands around the shipping carton.
• Lift carton off the generator.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping pallet.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged, call
the generator helpline at 1–800–270–1408. Contents
include:
• The main unit
• Owner’s and engine manuals
• 2 bottles engine oil
• 125 Volt, 30 Amp plug
• 125 Volt, 20 Amp plug
• 120/240 Volt, 30 Amp plug
• Battery charge cable
• Wheel kit
ASSEMBLE WHEEL KIT
If you have any problems with the assembly of your
generator, please call the generator helpline at
1–800–270–1408.
IMPORTANT: This wheel kit is not intended for
over–the–road use.
To install your wheel kit you need the following tool:
• 13 mm box, open end, or socket wrench
Install Wheel Kit as follows:
1. Place temporary blocks on a flat, even surface and
place the bottom of the generator cradle on the
blocks.
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 2.
3. Slide a wheel spacer over each end of the axle.
4. Install a wheel on an axle and slide a flat washer over
the axle. Secure the wheel with retaining pin.
NOTE
: Be sure to install each wheel with the air
pressure valve on the outboard side.
5. Install the other wheel in the same manner.
6. Secure the vibration mount to the support leg with a
lock nut, a flat washer and a 30 mm long capscrew.
7. Secure the support leg assembly to the cradle with
20 mm long capscrews, flat washers, and lock washers.
8 Position the handle on the cradle end opposite the
control panel. Secure the handle with 45 mm long
capscrews and lock nuts.
9. Tighten all lock nuts with the 13 mm wrench to ensure
all components are secure.