Smart IP Manager - System Operating Manual
page 42 of 48
on the WLAN service and assign it to an IP address in the same network with the Smart IP
loudspeakers.
Figure 39. Genelec Smart IP control network on simple network containing a WLAN access point,
IP switch with PoE output to Smart IP loudspeakers.
6.3 Configuring Smart IP Controller App
Follow these steps to configure each zone. To add zone definitions (shown in Figure 47) to the
Smart IP Controller do the following:
1. Launch the Smart IP Controller app. Wait until it has found all the loudspeakers in the
network. Ensure that the number of speakers found matches the actual number of
loudspeakers and zones. Then proceed. If not, try rescanning.
Figure 40. The number of Smart IP zones and speakers found by Smart IP Controller app.
After finding all the loudspeakers, you are now ready to start entering the configurations.
2. Start adding the first zone by clicking the ‘+’ button.
If it exists, the ‘Default zone’ will be shown.
To add more zones besides the Default zone, jump to step 9 and then continue from step 4.
Continue until all zones you want to show have been set up.
