- For GENELEC 8260A, 8351A, 8250A, 8050A (with included adaptor plate)
- For GENELEC S360 (S360-424B U-bracket mounting adapter needed!)
- Check for damage prior to and after use. Damaged mounts my not be used again.
- Not suitable for outdoors or moist rooms.
- Observe the local mounting regulations (they may deviate from the examples presented here).
- Only mount on suitable walls with the corresponding assembly material (not included in the delivery).
-
Examples - see Point 4.A/B/C. Observe the placement instructions provided by the anchor
-
manufacturer.
-
Not suitable are fragile walls. Beware of power supply lines and water conduits. In case ask an expert.
- Only use trained technicians to assemble the system.
- Ensure that the screws are tight and load-bearing, in particular as regards the setting of the
-
loudspeaker angle.
- Inspect bolted assemblies periodically
- The placement of the loudspeakers requires two physically fit qualified technicians.
- Careful and attentive handling is required when adjusting the stand - due to the possibility of pinching
-
or wedging your hand.
- External influences such as bumping into the loudspeakers, brushing into the loudspeakers, things
-
thrown at the loudspeaker, wind etc. represent a risk and must be avoided. Measures: Compliance
-
with safety distances, keeping unauthorized persons at a distance, if needed put safety cordons.
- The instructions provide directions to all of the important setup
-
and handling steps.We recommend,you keep these
-
instructions for future reference.
Instruction manual
5. Installation
6. Settings
7. Dimensions
Safety instructions
5.b
Bolt the monitor
to adaptor plate.
Use four screws
M6 x 14 mm
with washers
For horizontally
mounting of the
GENELEC 8351
turn the adaptor
plate
5.a
Bolt the U-bracket
to the adaptor plate.
Use three safety nuts
M6 with washers.
6.a
Continuously adjustable
up to 30°, by fixing the
upper bolted assembly
7.a
hole pattern:
127 x 70 mm - M6
&
VESA 100 x 100 - M4/5
7.b
Weight: 1.8 kg
6.b
Pivoting attachment
around vertical axis
5.c
Replace swivel joint (with mounted monitor)
into wall bracket
GENELEC
Oy
Olvitie 5, Fin-74100 Iisalmi, www.genelec.com
24478-018-55 Rev.02 03-80-362-00 10/18
S360-444B GENELEC Wall Mount for GENELEC S360, 8260, 8x5x
5.d
Secure swivel joint
to the wall bracket
by tightening lower
bolted assembly
Tightening
torques
10 Nm
Tightening
torques
11 Nm
Tightening
torques
9 Nm
