User Manual
GWR High Speed Cellular Router Series
101
Scenario #2
Router 1 and Router 2, presented in the
Figure 64
, are configured with IPSec tunnel in Main mode.
Configurations for Router 1 and Router 2 are listed below.
The GWR Router 1 configuration:
Click
Network
Tab, to open the
LAN NETWORK
screen. Use this screen to configure LAN TCP/IP settings.
Configure IP address and Netmask:
IP Address: 10.0.10.1
Subnet Mask: 255.255.255.0
Press
Save
to accept the changes.
Figure 87– Network configuration page for GWR Router 1
Use SIM card with a static IP address, obtained from Mobile Operator.
Click
WAN Settings
Tab to configure parameters necessary for GSM/UMTS/LTE connection. All
parameters necessary for connection configuration should be required from mobile operator.
Check the status of GSM/UMTS/LTE connection (
Mobile Settings
Tab). If disconnected please click
Connect
button.
Click
VPN Settings
>
IPSEC
to configure IPSEC tunnel parameters. Click
Add New Tunnel
button to
create new IPSec tunnel. Tunnel parameters are:
Add New Tunnel
Tunnel Name: geneko,
Enable: true.
IPSec Setup
Keying Mode: IKE with Preshared key,
Mode: main
Phase 1 DH group: Group 2,
Phase 1 Encryption: 3DES,
Phase 1 Authentication: MD5,
Phase 1 SA Life Time: 28800,
Perfect Forward Secrecy: true,
Phase 2 DH group: Group 2,
Phase 2 Encryption: 3DES,
Phase 2 Authentication: MD5,
Phase 2 SA Life Time: 3600,
Preshared Key: 1234567890.
Local Group Setup
