02
•
All electronic components should be
installed or placed out of
chil
dren's reach
•
Do not use other power cords except for what is provided with the screen
•
Do not attempt to repair anything, without consulting a qualified technician
•
Make sure the line voltage corresponds to the power of the receiving host
before use. Unplug the receiving host when unused for long periods of time
•
Must use the three-phase power socket and make sure there is a ground
contact
•
Do not install or place the device near any heat sources, such as a furnace, heat
transfer tube, power amplifier, etc. Do not expose this device to direct sunlight,
dust and moisture. Do not install the device in any place which may have
mechanical vibrations or could lead to a vulnerable strike. For better
performance, it should be placed far away from high voltage transmission grid,
large metal objects and so-on
•
Disconnect the power immediately and unplug when there is abnormal sound
or smell in the device. Do not use the device and call the qualified service
personnel for maintenance
•
There should not be any liquid or other metals in the device. If any, power off
and disconnect the power and call the qualified service personnel
•
Do not use any chemical reagent for the device’s body cleaning as it may result
in deterioration or damage to the paint. For any dust or dirt, use a warm cloth
and clean it after power disconnected. The IR Touch LED Display should be
gently wiped down with a clean soft cloth, when dirty
•
Do not turn on and off the device frequently as it will shorten the service life of
the device. Turn on the device three minutes later after a normal power off
•
Do not set the brightness and contrast ratio to maximum in long term so as to
lengthen the service life of the device
•
Do not place the device on an unstable stand bracket or desk, or else the
device might tip over and get damaged
•
Take extra care when moving the device to avoid any damage to the screen
•
Should follow the operation manual of the manufacturer and install this device
and should only use the accessories for installation recommended by the
manufacturer
•
The wall mounting of the device is only applicable on a cemented wall, solid
masonry wall and a wood siding wall that could bear more than three times
the weight of the device and should also be good for ventilation. For other
walls such as a Steel structure wall or one with a hollow structure or a glass or
marble wall. The walls ability to bear the device should be analysed to make
sure that there will be reduced risks.
Key Notes:
Notes
