Genebre Building. Av. de Joan Carles I, 46-48
08908 L'Hospitalet de Llobregat. Barcelona (Spain)
[email protected] - www.genebre.es
GENEBRE S.A.
LAST UPDATE: 16/07/2020 UPDATE NUMBER: 0
4
2. Storage
During storage it is recommended to keep the Gear Operator in the same position as
delivered, with the included protective wrapping to avoid damages or dirt accumulation. The
wrap must not be removed until the operator is to be installed. As far as possible, store in a
dry and clean environment. If you expect to have the product stored for a long period of time,
apply anti rust oil over machined areas. Repeat every 6 months if necessary.
3. Installation instructions
3.1 Preparation
Remove any wrapping material from the product.
The Gear Operator is delivered in the closed position.
3.2 Assembling to the valve
1- Check if the bolt circle on top flange and stem dimensions of the valve coincide with the
bolt circle and square hole of the gear operator, respectively (connection according to ISO
5211 standard).
2- Make sure that both valve and gear operator are in fully closed position.
3- Mount the gear box with its shaft perpendicular to the valve (or pipeline) by means of the
attached four screws and washers. Apply "cross method" for tightening.
3.3 Assembling to the actuator
1- Check if the holes and pinion dimensions of the actuator coincide with the holes and
square of the gear operator, respectively (connection according to ISO 5211 standard).
2- Make sure that both actuator and gear operator are in fully closed position.
3- Mount the actuator with its shaft parallel to the pipeline) by means of the four screws and
washers. Apply "cross method" for tightening.
