ENC-3300-DTMF
Programming
If the encoder is not yet programmed, insert the 2GB SD memory card containing
the DTMF settings then reset power to the encoder. The program information will
be transferred to the encoder as it starts.
Open the access door on the ENC-3300 to
insert or remove the memory card.
To insert, slide the card into the card holder
until it latches into place.
To remove, lightly press the memory card
down to release it from the card holder. It will
pop up slightly and can then be removed.
During a program upload the encoder actively
monitors the new data as it arrives and
searches for possible errors or corrupted data. It saves the results of the search in a report file on the
SD card. The report file has the same name as the file just uploaded, but with a suffix of .RPT (Report)
instead of .GP3. To verify the transfer it's recommended this report be examined with a text editor such
as Windows Notepad after an upload.
See Programming via SD Card on page 20 for additional information.
Testing
Reattach the access door. Test the encoder and radio completely before placing into service. Check
the transmitter deviation, signal symmetry, and all codes and actions using a communications service
monitor, oscilloscope and associated test equipment.
Genave/NRC,Inc. 9000-0000-086 rev 4
Pg. 14
