ENC-3300-DTMF
Installation
The ENC-3300 attaches to a customer supplied two-way
radio to generate over-the-air DTMF signals intended to
control remote equipment and pagers.
Audio, PTT and carrier detect lines from the radio are
attached to the ENC-3300 using connector J3.
Access to connector J3, testing and adjustment controls
is performed by removing two screws from the bottom of
the door, then pulling the lower edge of the door forward
and out and setting the access door aside.
Output Connector
Connect the appropriate wires between your radio to the encoder. See the Output Schematic on page
44 or Radio Interface on page 25 for additional information.
The ENC-3300 includes a 9 position depluggable connector for connections to the external radio.
Connectors and cables for specific radios are not included with the encoder.
Genave/NRC,Inc. 9000-0000-086 rev 4
Pg. 11
Depluggable Connector J3
