LRAD
1950XL
GENASYS INC.
Manual Part No.:114931-00 rev. B
10
104758-00
PACKAGING, CRATE, LRAD-
1000X
3.2 Quick Setup Guide
The LRAD
1950XL can be quickly set up for use by following these basic steps. Reference the
pictorial parts list in the previous section to identify the parts mentioned below.
AC
outlet
1. Install the mounting yoke in an appropriate mounting system. LRAD offers various
mounting options.
2. Place the rubber washers from the tilt lock knob kit over the tilt axis studs so they are
flush with the tilt axis flanges.
3. Lower the head unit onto the yoke, inserting the studs into the vertical slots in the yoke.
4. Screw the tilt lock knobs onto the tilt axis studs and tighten.
5. Install the removable handles on the back of the head unit.
6. Open the lid of the amp pack.
7. Connect either the 50 foot or 12 foot AC power cord and connect to an AC power outlet.
8. Connect the 35 foot amp pack to head unit cable.
9. Connect the 20 foot remote control cord to the amp pack and to the MP3 control
module.
10. Connect the microphone to the control module.
WARNING
: Always wear hearing protection when operating the LRAD.
