RPT-100
User Manual
Date
2017-08-03
Rev
2.1
Page
70
CONFIDENTIAL
Document Gen2Wave. All rights of reproduction and disclosure reserved.
5.3.
How to Use
①
Select the serial port through the serial port drop down menu.
If it is connected via USB, Magconn™ cable, or Bluetooth, a port that can connect with the
device program will be created. (The port number may differ from the illustration below)
②
Press the Open button and the connection will be changed as shown below.
(Open Port button to Close Port button on)
③
You can select the command to transfer to device from RSP command list. Please refer to the
"
RSP Interface Programmers Guide
" for command and detailed explanation.
④
You can input Command directly from the Input Command drop down menu.
[Note]
You can use the Command only if the serial port is properly connected.
[Note]
Program’s General Commons > “Open_Comm” command must be executed first.
⑤
Commands can be sent to the device through the command transfer button.
⑥
You can check the result of command transmission /reception from “Transmit / Receive” window..
⑦
Through RSP command property window, ③ Properties for command selected in RSP
command list are displayed. Parameter properties can be changed by the user.
⑧
Explanation of the command selected in the RSP command list is displayed through the RSP
command description window..
⑨
Receive data window ⑥ Transmit / Receive data window can be cleared by the clear button.