background image

 

Federal Communication Commission Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 

residential  installation.  This  equipment  generates,  uses  and  can  radiate  radio  frequency  energy  and,  if  not 

installed and used in accordance with  the  instructions, may cause harmful  interference to radio  communications.   

However, there is no guarantee that interference will not occur in a particular installation.    If this equipment does 

cause harmful  interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one of the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could 

void the user's authority to operate this equipment. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This 

device may not cause harmful  interference, and (2) this device must accept  any  interference received,  including 

interference that may cause undesired operation. 

IMPORTANT NOTE: 

Radiation Exposure Statement: 

This  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an  uncontrolled  environment.  This 

equipment should be installed and operated with minimum distance 

 cm between the radiator & your body. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

The  availability  of  some  specific  channels  and/or  operational  frequency  bands  are  country  dependent  and  are 

firmware programmed at the factory to match the intended  destination. The  firmware setting  is not accessible by 

the end user. 

Due  to the essential high output power natural of WiMAX device,  use of this device with other transmitter at the 

same  time  may  exceed  the  FCC  RF  exposure  limit  and  such  usage  must  be  prohibited  (unless  such  co-

transmission has been approved by FCC in the future). 
 
 

29

Summary of Contents for WIXS-181






Reviews: