background image

 

PoE Installation   

 

1.  The unit can be placed on a desktop or a shelf. Alternatively, it may be wall-mounted.   
2.    Connect the PoE-ODU cable to the DATA & POWER OUT port.     
3.    Connect the PoE to the AC mains. 
4.    Connect ETHERNET port to a PC/Hub/Switch.   

 

Basic Configuration 

 

1.    Use the Web Configuration Server to configure the basic parameters.   
2.    Connect a PC/Notebook to the POE. 
3.    By default, the CPE enables a DHCP server and computers or network devices connected to a LAN port to 

automatically get an IP address from the CPE. If the CPE's DHCP server is disabled, you can set the IP 
address, netmask, and gateway manually using the following parameters: IP address: 10.1.1.x, 1 < x < 253; 
Netmask: 255.255.255.0; Gateway: 10.1.1.254.   

4.    Open a web browser, and connect to http:// 10.1.1.254/. The Login page is displayed. Enter the user name: 

admin, password: admin and click Login.   

5.    Configure the parameters, as needed.   
6.    Reset the unit to apply the changes. 

 

Aligning the ODU's Antenna 

 

1.   Point the ODU toward the general direction of the serving BS.   
2.   Verify that the unit is synchronized with a BS. If the unit is not synchronized with a BS, ensure that all 

parameters are configured properly. If the unit is still not synchronized with a BS, improve the quality of 
the link by changing the direction of the ODU or by placing the ODU at a higher or in an alternate 
location.   

3. Ensure that the front of the ODU is always facing the location of the BS. However, in certain conditions, 

such as when the line of site to the BS is hampered, better reception may be achieved using a 
reflected signal. In this case, the ODU is not always directed toward the BS.   

4. Secure the unit firmly to the pole. 

 

Verifying Proper Operation 

Verify data connectivity by pinging the BS or by connecting to the Internet. 

Summary of Contents for WIXS-181






Reviews: