BrilliantSpa
Pro
Manual
7
hot water from its nozzle until the water level in the tank has
been reduced to a sufficient level so steam may be produced.
4. Replace the water fill cap by hand tightening. Do not over-tighten.
Over-tightening could result in damage to your water fill cap gasket
and consequently your steamer will not pressurize properly.
An
additional gasket has been supplied with your unit in the event
you damage the gasket.
5. Plug in the BrilliantSpa PRO to a grounded electrical outlet
that has a power rating sufficient to operate the appliance.
Locate the rear power switch and flip it to the “I” position to
turn it on. Within approximately 3 minutes it will automatically
heat up the water in its tank creating pressurized steam.
The red LED light will indicate that the steamer is heating
up the water in its tank and building pressure.
6. When the green LED lights up that indicates that it is ready
to be used. Please note that the green LED light will
cycle on and off as the steamers thermostat automatically
heats up while maintaining constant pressure.
7. Place the jewelry in the handheld basket or while using the
tweezers to hold it, firmly yet carefully grasp the item and
hold it approximately one inch beneath the steam nozzle.
8. Press the steam activation lever to release steam. The
steamer works best when using short, one or two second
bursts of steam. Allowing a brief delay between bursts
gives the steamer time to rebuild steam pressure. To clean
an item on all sides, rotate the item under the nozzle.
Allow the jewelry time to cool before wearing.
9. Inspect the item after cleaning and if it requires additional steam
cleaning repeat step #8. For dirtier items, additional steaming time
may be required. Pre-soaking the item in hot water will help loosen
up the dirt. For faster results, it is also recommended to first use
the GemOro Sparkle Spa, or Sparkle Spa Pro personal ultrasonic
jewelry cleaner (sold separately). These ultrasonics will quickly
loosen up the dirt and pre-clean it prior to steaming.
10. Residual water will collect in the water residue cup as the steam
cools. Empty the water as needed.
11. When it is necessary to refill the BrilliantSpa PRO, first turn it off
and then unplug it from the power outlet. Allow sufficient cooling
time of approximately 30 minutes prior to refilling the tank. When
