1
4
Operation
Parts Description
BELT PACK TRANSMITTER
2
3
Parts Description
HANDHELD MIC
1. Grille(Capsule inside)
2. Power/low battery Indicator
3. Power ON/OFF/MUTE Switch
4. Battery Compartment/Cover
1
4
Operation
2
3
1. Open battery cover. Install the provided 2pcs 1.5V AA batteries and
then close the cover. Pay attention to the correct polarity.
Push power switch to ON position, power indicator should flash
once briefly indicating that the transmitter has sufficient power. If
the power LED indicator stays on, it indicates that the battery has
insufficient power and should be changed. If the power LED
indicator does not light at all and the transmitter does not work, it
indicates the battery is dead and you should change the battery.
If the microphone is not going to be used for any length of time,
push power
switch
to
OFF
position
and
remove
the
battery.
2.
3. Now receiver RF indicator should light(Please confirm frequency of
microphone same as that of receiver before operation).
4. Push power switch to MUTE position to mute the sound.
5. During operation if power indicator lights red, this indicates the
battery is Iow. Please replace new battery.
6.
1. Open battery cover. Install the provided 2pcs 1.5V AA batteries and
then close the cover. Pay attention to the correct polarity.
2. Insert headset MIC or clip-on MIC plug into MIC IN jack. And turn
plug clockwise to lock the headset MIC.
3. Slide power switch to ON position, power indicator should flash
once briefly indicating that the transmitter has sufficient power. If
the power LED indicator stays on, it indicates that the battery has
insufficient power and should be changed. If the power LED
indicator does not light at all and the transmitter does not work, it
indicates the battery is dead and you should change the battery.
5. Slide power switch to MUTE position to mute the sound.
6. If the transmitter is not going to be used for any length of time, push
the
power
switch
to
OFF
position
and
remove
the
battery.
4. Now receiver RF indicator should light. Please confirm frequency of
transmitter is same as receiver before operation.
1. Power ON/OFF/MUTE Switch
2. Power/low battery Indicator
3. MIC in jack
4. Battery Compartment/Cover
