5.0 - EMERGENCY DISARMING BY PIN-CODE
The system can be disarmed by entering the 4-digit emergency PIN-CODE as indicated in the
example below.
Please be aware that the default PIN-CODE is factory set as 1-1-1-1.
The example below considers the PIN-CODE previously programmed “5-4-6-7”.
If, when disarming with the PIN-CODE, the LED flashes more than 9 times, the
procedure will be considered a theft attempt.
!
!
!
!
!
!
!
!
!
!
!
!
!
Generate an alarm condition.
Let the alarm sound for the set period of time (approx. 30 seconds) and wait for the alarm inhibit
time between 2 alarms (LED OFF for 5”).
During this lapse of time, press and release the button on the status LED.
“emergency disarming procedure” and the LED will start flashing.
, press and release the
button on the status LED.
After a 3 second pause, the status LED starts a new blink sequence of 9 flashes.
At the
and release the button on the status LED.
After another 3 second pause, the status LED repeats the blink sequence of 9 flashes.
At the 6 flash,
3 digit (6), press and release the button on the status LED.
After a 3 second pause, the status LED gives the last blink sequence of 9 flashes.
At the 7 flash,
4 and last digit (7), press and release the button on the status LED.
If the code is correct, the system disarms and the end of the procedure is confirmed by
visual/acoustic signals.
th
th
th
rd
The system is now in the
At the 5 flash, which corresponds to PIN-CODE 1 digit (in this case, 5)
4 flash, PIN-CODE 2 digit (4), press
PIN-CODE
PIN-CODE
If, on the other hand, the code is incorrect, an alarm will be triggered. In this case, repeat the entire
procedure.
th
th
st
nd
6.0 - WARRANTY CONDITIONS
This product is guaranteed to be free from manufacturing defects for a period of 24 months from the
installation date shown on this warranty, in compliance with Directive 1999/44/CE.
Please fill-in entirely the guarantee certificate included in this booklet and do NOT REMOVE the
guarantee label from the device.
The warranty will become void if labels are missing or torn, if the installation certificate is not fully
compiled or if the enclosed sale document is missing.
The guarantee is valid exclusively at authorized Gemini Technologies S.p.A. Service Centers.
The manufacturer declines any responsibility for eventual malfunctions of the device or any damage
to the vehicle electrical system due to improper installation, use or tampering.
This alarm system is solely intended to be a theft-deterrent device.
PAGE 06 - USER MANUAL
USER MANUAL - PAGE 07
7.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
The present device does not fall within the scope of Directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE) as specified in art. 2.1 of L.D. no. 151 of 25/07/2005.
