20.0 - TECHNICAL SPECIFICATIONS
To reset the system proceed as follows:
power supply
hort-circuit the RED and BLACK wires of the 2-way
connector
4 acoustic signals and 4 flashes of the turn indicators will confirm the alarm is
powered
Remove the previously created short-circuit; the status LED lights up steady.
reset is confirmed by an aucoustic signal and the wailing of the siren for
approx. 3 seconds
the LED turns off without any audio signals.
!
!
!
!
!
!
Disconnect the alarm
.
S
LED
.
Connect the alarm:
.
Turn ignition key “ON”;
.
Turn ignition key “OFF”;
By activating the following procedure, the system returns to the
factory default setting.
This procedure must therefore only be carried out in case of need, before programming
the system, learning the turn indicators flashes
before programming the new
PIN-CODE
or
.
18.0 -
18.1 - CO
18.2 - SENSOR ADJUSTMENT
I
I
.
T
:
.
ULTRASONIC VOLUMETRIC PROTECTION
NNECTION AND POSITIONING
nsert the WHITE connector in the “W” marked socket.
nsert the RED connector in the “R” marked socket (see figure below).
Install the transducers for the ultrasonic sensors on the top part of the windshield internal pillars, away
from the air vents and orient them towards the center of the rear window
o check sensitivity level proceed as follows
With the alarm system disarmed, roll down the front window about 20 cm.
Adjust trimmer at a medium setting.
Close all doors, bonnet and boot and arm the system.
During the alarm inhibit arming time introduce an object in the cabin through the window and move
it around; the status LED will turn off to signal a presence.
If sensitity level is too high or too low, readjust the trimmer and repeat the above procedure
!
!
!
!
!
19.0 - SYSTEM RESET
PAGE 18 - INSTALLER MANUAL
INSTALLER MANUAL - PAGE 19
ULTRASONIC
CELLS
CONNECTIONS
SENSITIVITY
ADJUSTMENT
!
Power supply
Current absorption @ 12Vdc with system armed and LED flashing
Working temperature range
Turn indicators relay contact capacity
Alarm cycle duration
Maximum positive current output when armed (+A)
Maximum load on siren output
12 Vdc
15 mA
-30°C to +70°C
8 A at 20°C
30 sec.
700 mA
1 A