Stop operation
1. Button "0" is pressed;
2. stop signal is detected if wire control is selected
3. Fault occurred
If the pump is stopped normally as in the above case 1~3, the
"Power" LED flashes and the LED display shows "OFF", while the
LED shows an error code if the pump is stopped due to a fault.
When the power is turned on and the motor is at the standby
state, the LED display also shows “OFF” if there is no error, and the
power light flashes.
Start the pump
Manual operation
Press button
"1", "2" or "3
" to select the preset fixed speed or
preset fixed power.
If the pump starts from standby state, it starts up in priming mode
and subsequently runs with the selected fixed speed or fixed
power.
As long as the pump is in the priming phase, the light of the
selected speed or power flashes.
During running operation the pump will be accelerated or
decelerated to the selected fixed speed or fixed power directly,
without priming time.
Preset speed or power can be changed during running operation.
Please refer to “Presetting the fixed speed in constant speed
operation mode” for the change operation method.
