Document Reader AT9000 MK2 User Guide
Installing the Reader
Page 18 of 33
To reduce the risk associated with hazardous voltage which, if not avoided,
could result in death or serious injury:
Do not use the reader with any AC power supply other than the
provided Gemalto AC power supply.
1. Connect the USB cable:
I.
Insert the Type B connector into the USB port located on the back of the reader.
II. Insert the Type A connector into a USB port on the host PC.
2. If want to attach peripheral USB devices to the reader, you will need to connect the power supply (if
you are using the reader as-is, you can skip this step). To connect the power supply:
I.
Connect the connector from the power supply to the power connector at the rear of the
reader.
Do not force.
There is only one orientation that will allow the cable to be connected
to the power port.
II. Connect the AC cable to a functioning power outlet.
Power on the reader
To power on the reader press the power switch located on the back of the reader for approximately 0.5
second.
A power-on self-test occurs automatically when the reader powers up. If the reader is installed correctly
and is operational, the indicator lights will perform the following boot-up sequence:
All lights come on briefly at initial power-up.
During power-up self test the OK light (green) remains on while the Ready light (blue) flashes.
After approximately 10 seconds, the Ready light (blue) remains on and all other lights turn off
The lights may also indicate the following common communication errors:
The blue Ready light flashes rapidly if no USB connection is detected.
The blue Ready and red Error lights flash rapidly if a USB 1.1 connection is detected. The reader
will not transfer document images over a USB 1.1 connection.
Test the reader installation
After installing the reader, perform a quick test to ensure the reader is functioning properly and the
software was installed correctly.
To test the reader:
1.
Start the application
Page Reader Expo
from the shortcut created during software installation.
2.
Select a scheme that m
atches your reader. If you are unsure, select the “ePassport and Images”
scheme.
