V
12/13
OptiMove CR07
General safety regulations
•
7
Special security measures
1. It must be ensured, that all components are earthed according
to the local regulations before start-up.
2. The OptiMove CR07 axis control unit should be switched on
and operated only after carefully reading these operating
instructions. Incorrect operation of the axis control unit can
lead to accidents, malfunctions or damage to the plant.
WARNING!
The power of the axes is very much stronger than that of a human
being! All axes must be secured against access during operation
(see local regulations). Never stand under the Z carriage when the
reciprocator is not operating!
3. The installation work to be done by the customer must be
carried out according to local regulations.
4. The plugs and sockets of the axis control unit and the power
unit of the Reciprocator should only be unplugged when the
power supply is disconnected
5. The connecting cables between the control unit and the axis
must be laid in such a way, that they cannot be damaged
during axis operation. Please observe the local safety
regulations!
6. The
maximum upper stroke limit
of the reciprocator must
always be set with reference to the
maximum height of the
booth gun slots
. If an incorrect (too high) stroke limit is set,
this can lead to damage to the reciprocator and/or the booth!
WARNING:
During a test run, it must be guaranteed that the unit is not
damaged by the test! In particular, the limitations of the stroke
range have to be observed (for further information, see chapter
"System parameter P1 - Setting the upper mechanical stop")!
7. The voltage supply of the axis is guaranteed by the OptiMove
CR07 Axis control unit. The supply voltage amounts to 230
VAC and must always be conducted in the emergency stop
circuit. In case of an emergency, the voltage supply to the
motor may be interrupted with the emergency stop switch.
8. When repairing the axis, both the CR07 Axis control unit and
the axis must be disconnected from the mains according to
the local safety regulations!
9. Repairs may be done only by authorized Gema service
centers. Unauthorized conversions and modifications can
lead to injuries and damage to the equipment. The Gema
Switzerland GmbH guarantee would no longer be valid.
10. We point out that the customer himself is responsible for the
safe operation of the equipment. Gema Switzerland GmbH is
in no way responsible for any resulting damage.
