GEKKO GTO 22, Owner'S Manual

Page: 134 / 148

To unload the boat use the following procedure as a guide:
1. Make sure that all drain plugs are securely in place.
2. Unplug light cord before backing into the water.
3. If equipped with Boat Buddy, retract Boat Buddy latch pin by pulling trigger into
“safety” position. (If latch pin is bound, tighten winch to relieve pressure, then
pull trigger into “safety” position).
4 . With winch strap hook fastened, back the trailer until the water level is
approximately 1 inch below the top of the trailer fenders. NOTICE: Ramp slopes
vary, so actual level of water on trailer may be different.
5. Follow the cold start procedure recommended by engine manufacturer.
6. After starting the engine remove winch strap hook.
7. With engine idling, center steering wheel, engage transmission and slowly pull
throttle into reverse. Ease back on the throttle lever until the boat starts to
move.
IMPORTANT
DO NOT attempt to use excessive power to free the boat from dry carpet runners.
Power off of the trailer only when the boat has floated free from the carpeted
runners.
CAUTION !
If the trailer is not submerged to the correct depth, the bow of the boat could drop
when powering off incorrectly, possibly damaging the boat.
IMPORTANT
Because of the power configuration, when backing up, the stern may have a tendency
to drift left or right depending on propeller rotation.