GEKKO GTO 22, Owner'S Manual

Page: 110 / 148

The bilge inspection plate is located on the floor. Open the inspection plate by
unscrewing it to check the condition of the Bilge pump and wire harness or for water
in the bilge area.
IMPORTANT
Keep this area clean and free of dirt and debris.
Battery Cable Installation & Precautions TOP
On V drive models, the battery is mounted inside the rear port side storage
compartment. To access the battery, open the port side storage compartment hatch
lid.
On direct drive models, the battery is located in the under the deck storage area
behind the observers seat. To access the battery, lift the gull wing observer’s seat.
IMPORTANT
It is recommended that the battery cables be disconnected from the battery when the
boat is placed in storage.
Your Gekko electrical system is a negative ground type. The negative battery cable is
grounded to the engine block. The positive battery cable is connected to the starter
solenoid.
Connect the positive (+) battery cable to the positive (+) post on the battery. Connect
the negative (-) battery cable to the negative (-) post on the battery.