15
80587_eView HD_02-2019_ENG
7. BATTERY
These devices are equipped with rechargeable Lithium
battery, not user-replaceable.
The following information is maintained by the battery:
• hardware real-time clock (date and time)
Battery
Figure 7.1: eView HD 070, eView HD 101, eView HD 156, eView HD 215
8. SPECIAL INSTRUCTION FOR USE
- The equipment shall only be used in an area of not more
than pollution degree 2, as defined in IEC/EN 60664-1.
- The equipment shall be installed in an enclosure that
provides a degree of protection not less than IP 54 in
accordance with IEC/EN 60079-15.
- Transient protection shall be provided that is set at a level
not exceeding 140 % of the peak rated voltage value at the
supply terminals to the equipment.
- Install the HMI device according to the accompanying
installation instructions.
- Ground the HMI device according to the accompanying
installation instructions.
- Only qualified personnel may install the HMI device or
repair it.
- Ensure that the aeration holes are not covered.
- Care shall be taken not to allow layers of dust to form on the
graphic panel in a way that might cause the accumulation of
static charges. Keep the faceplate of the HMI device clean:
the equipment must be cleaned only with a soft cloth and
neutral soap product. Do not use solvents.
- This device should not be used for purposes and
methods other than indicated in this document and in the
documentation accompanying the product.
9. GETTING STARTED
eX Series 700 HMI products delivery configuration is based on
a loader. Use the services of the loader to install applications
on the device such as GF Designer HD runtime or browsers.
GF Designer HD Studio version V2.6 or higher is required. GF
Designer HD is a software tool that must be properly installed
on a computer running Microsoft Windows.
There are two options to transfer a GF Designer HD application
project to a HMI device:
Ethernet
Connect the HMI device to the computer with
an Ethernet network. In GF Designer HD Studio
select the command Run/Download to target.
You may have to ensure that the proper firewall
policy has been configured in the computer to
allow GF Designer HD Studio to access the
network.
USB
Create an Update Package using GF Designer
HD Studio and copy it to a USB Flash drive
ATTENTION
Dispose of batteries according to local
regulations.
Charge:
At first installation must be charged for 48 hours.
When the battery is fully charged, it ensures a period of 3
months of data back-up at 25°C.
ATTENTION
This device cannot be disposed of as
a domestic waste but according to
WEEE European Directive 2012/19/EU
