15
1. Insert a small fl at head tool into the trim pot on the receiver unit.
2. Turn the trim pot in a clockwise fashion until it comes to a stop. Do not force
the trim pot beyond this point. Doing so may break the trim pot.
3. Slowly turn the trim pot counter-clockwise in millimeter increments until the
image stabilizes and all video noise disappears.
4. Carefully remove the adjustment tool.
NOTE:
If your cable run is beyond 130 feet, or the following steps do not produce
any video, it may be necessary to increase the boost from the sending unit. Use
the chart below to increase the boost by changing the sender dip switches. Once
a new boost setting is set, repeat steps 1 through 4 from above.
Equalization Setting
Setting
Switch 1
Manual EQ
ON
Auto EQ (Default)
OFF
Boost Setting
Setting
Switch 4
Switch 5
No Boost (Default)
OFF
OFF
Medium Boost
OFF
ON
High Boost
ON
OFF
Very Low Boost
ON
ON
IR Remote Channel Confi guration via DIP Switches
Dip Switches 2 and 3 relate to the IR remote control channel that is used by the
4x4 HDMI Over CAT5 Receiver and RMT-4IR remote control. Dip Switch 2 and
3 on the 4x4 HDMI Over CAT5 Receiver must match Dip Switch 1 and 2 on the
RMT-4IR remote control. Each 4x4 HDMI Over CAT5 Receiver and remote pair,
should be set to a different channel so that no two units do receive confl icting IR
commands. Please view the table below to set the channel on each of the 4x4
HDMI Over CAT5 Receiver units and IR remote controls. The remote channel for
the RMT-4IR is located underneath the battery cover.
CONFIGURING THE 4X4 HDMI OVER CAT5 RECEIVER
Remote Channel 1:
Default
1 2
Remote Channel 2:
1 2
Remote Channel 3:
1 2
Remote Channel 4:
1 2
Remote Channel 1:
Default
2 3
Remote Channel 2:
2 3
Remote Channel 3:
2 3
Remote Channel 4:
2 3
RMT-4IR REMOTE CONTROL
4x4 HDMI Over CAT5 Receiver
