Gefen EXT-DVI-2500HD, User Manual

Page: 9 / 20

5
1 LED Power Indicator
This LED will become active once the included 5V DC power supply is properly
connected between the sender and an open wall power socket.
2 EDID Mode Selector Switch
This switch will set either the Direct DDC or Virtual DDC modes. For a
description of these modes please see page 8.
3 Self-EDID Button
This button will begin the EDID recording process when the DVI•2500HD is
operating in Virtual DDC mode. This button does not have any use in Direct
DDC mode.
4 EDID Program LED Indicator
This LED will become active after the Self-EDID button is pressed. This is to
indicate that the sending unit is ready to record the EDID of the connected DVI-
capable device.
5 LED Status Indicator
This LED will become active once the DVI source device has been properly
connected and detected. This indicator will also become active when the
sending unit is ready to record EDID after the Self-EDID button is pressed.
6 12V DC Power Receptacle
This receptacle will require power from the included 12V DC power supply for
proper operation. Connect the included power supply between this port and an
open wall power socket.
7 DDC RJ45 Port
This port is used to connect a CAT-5e cable between the sending and receiving
units for DDC2B traffic. This cable is only necessary when the DVI•2500HD is
operating in Direct DDC mode.
8 DVI-D Input
This receptacle will accept either a DVI Single-Link or Dual-Link source device.
9 2 Port LC Fiber Receptacle (Channel 1)
This receptacle will accept 1 pair, or 2 single-strand, LC terminated fiber optic
cables. This cable is required at all times for operation.
10 2 Port LC Fiber Receptacle (Channel 2)
This receptacle will accept 1 pair, or 2 single-strand, LC terminated fiber optic
cables. This cable is only required for operation when Dual-Link sources are
used.
SENDER PANEL DESCRIPTIONS