Gefen EXT-DV- 3600HD, User Manual, Page: 12 / 20

8
RECEIVER PANEL DESCRIPTIONS
1 Reset
This button is used to cycle the power off and on. In most cases this will force
the source to re-establish a link with the endpoint device. This will also force the
source to re-read the EDID.
2 Remote
This LED indicator will glow bright green when USB control is set to Remote
mode (see page 13). When this LED is active, the USB ports on the Receiver
unit will be active and the USB ports on the Sender unit will disabled.
3 Ch B
This LED indicator will glow bright green when a valid optical link exists between
channel B (LC-
fi ber connectors) on the Sender unit and channel B on the
Receiver unit (see page 7).
4 Status
This LED indicator will glow bright green when all devices are properly
connected and that both the Sender and Receiver unit are working properly.
5 Power
This LED indicator will glow bright red once the included 12V DC power supply
has been properly connected between the Sender unit and an available
electrical outlet.
6 Ch A
This LED indicator will glow bright green when a valid optical link exists between
channel A (LC-
fi ber connectors) on the Sender unit and channel A on the
Receiver unit. See #18.
7 12V DC
Connect the included 12V DC power supply to this power receptacle.
8 RS-232
Connects to the RS-232 control device. The
DVI 3600 HD
may be controlled
D
remotely using this port.
9 Audio Out
Connect an audio/video device to this jack using a 3.5mm mini-stereo cable.
10 Remote
Reserved for future use. This port is not used.
11 USB
Connect up to four USB devices to these ports. These USB ports are active only
when the control switch is set to
Remote
.