Geely EC715 2009, Workshop Manual

Page: 1766 / 2181

Door Status Display
Four doors information is from the CAN bus, sent by the BCM
module. Instrument cluster shows each door information on
LCD display. When the vehicle speed is greater than 10 km/h,
if a door opens, the corresponding LCD segment will be
blinking, body icon shows on LCD, buzzer will ring until all
doors are closed; when the speed is less than or equal to 10
km/h, if a door opens, the corresponding LCD segment will be
lit (not blinking), body icon shows on LCD, but the buzzer does
not ring.
When the engine is shut down, if a door opens and there is no
other alarm, the LCD will show the door open status for 4 s.
The instrument panel goes into sleep mode, while there is no
LCD information display, no backlight.
When the engine is shut down, if the engine hood opens or the
rear compartment lid opens and there is no other alarm, then
the LCD backlight illuminates. LED shows corresponding
status, also shows the status of each door. After 4 s, the
instrument panel goes to sleep. At the same time there is no
LCD information display, no backlight.
If the key is not pulled out or park lamps are not turned off,
although the engine is shut down, the LCD will be backlight on.
LCD shows the status of each door until the alarm expires or
the alarm is deactivated. After the alarm, instrument panel goes
to sleep. At the same time there is no LCD information display,
no backlight.
When the engine is shut down, if the hazard warning lamp is
enabled, then the LCD backlight will be on, the right and left
turn signal lamps start flashing. LCD shows the status of each
door until the hazard warning lamp is turned off. If there is no
other alarm, the instrument panel goes to sleep. At the same
time there is no LCD information display, no backlight.
Odometer
Display Range: 6 digits, maximum 999,999 km
Accuracy: 1 km
Odometer shows the total vehicle mileage. When the total
mileage reaches the maximum reading (999,999 km), the
display remains unchanged. In order to prevent a total mileage
value loss, micro-controller updates the value stored in
EEPROM once every 2 km. When battery power supply is off,
the total mileage maximum error is 1 km. If reading from the
EEPROM fails, the corresponding display position shows "Err".
After the ignition is turned on, the micro-controller checks the
RAM for the total mileage value. If the RAM value is missing or
invalid, a total mileage reading from the EEPROM will be
displayed on the LCD. The value of the total mileage is stored
in RAM, and its accuracy is 1 km.
In the event of the battery power-down, the engine will be shut
down. Press the mode switch button, ignition on, and maintain
for 20 s. The odometer value is cleared (only when the reading
is less than 256 km). This operation can only be operated once.
11-282 Instrument / Driver Information System Body Electric
EC718/EC718RV EC715/EC715RV 10/2009