background image

13.  Unplug this apparatus during lightning storms or 

when unused for long periods of time.

14.  Refer all servicing to qualifed service personnel. 

Servicing is required when the apparatus has been 

damaged in any way, such as power-supply cord 

or plug is damaged, liquid has been spilled or 

objects have fallen into the apparatus, the 

apparatus has been exposed to rain or moisture, 

does not operate normally, or has been dropped.

NOTE: This equipmenthas beentestedand found to comply or has 
been dropped.
with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. 
This equipment generates, uses, and can radiate radio frequency 
energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for 

help .

The apparatus shall not be exposed to dripping or splashing and 

that no objects flled with liquids, such as vases, shall be placed 

on apparatus.

Main plug is used as disconnect device and it should remain readily 

operable during intended use. In order to disconnect the apparatus 

from the mains completely, the mains plug should be disconnected 

form the mains socket outlet completely.

Battery shall not be exposed to excessive heat such as sunshine, 

fire or the like.

Caution marking is located at the rear or back of the apparatus.

The marking information is located at the rear or back of apparatus.

L’appareil ne doit pas être exposé aux écoulements ou aux 
éclaboussures et aucun objet ne contenant de liquide, tel qu’un 
vase, ne doit être placé sur l’objet.

La prise du secteur ne doit pas être obstruée ou doit être facilement 
accessible pendant son utilisation. Pour être complètement 
déconnecté de l’alimentation d’entrée, la prise doit être débranchée 
du secteur.

Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à
la lumière du soleil, au feu ou autres choses de semblable.

Attention marquage est situé à l’arrière ou à l’arrière de l’appareil.

Les informations de marquage est situé à l’arrière ou à l’arrière de 
l’appareil.

FCC Warnings

Additional Warnings

1 Read these Instructions.

2 Keep these Instructions.

3 Heed all Warnings.

4 Follow all instructions.

5 Do not use this apparatus near water.

6 Clean only with a dry cloth.

7 Do not block any ventilation openings. Install in 

accordance with the manufacturer’s instructions.

8 Do not install near any heat sources such as radiators,

heat registers, stoves, or other apparatus (including 

amplifers) that produce heat.

9 Do not defeat the safety purpose of the polarized or

grounding - type plug. A polarized plug has two blades 

with one wider than the other. A grounding type plug 

has two blades and a third grounding prong. The wide 

blade or the third prong are provided for your safety. 

When the provided plug does not ft into your outlet, 

consult an electrician for replacement of the obsolete 

outlet.

10 Protect the power cord from being walked on or 

pinched particularly at plugs, convenience receptacles, 

and the point where they exit from the apparatus.

11 Only use attachments/accessories specifed by the 

manufacturer.

12.

Important Safety Instructions

Use only with a cart, stand, tripod, 

bracket, or table specifed by the 

manufacturer, or sold with the apparatus. 

When a cart is used, use caution when 

moving the cart/apparatus combination 

to avoid injury from tip-over.

2

Summary of Contents for LP-56U-BT














Reviews: