H
ow
T
o U
se
13
Sleep
Installation For Use
Start cleanup
If the robot is paused and not connect the charging dock for over 10 minutes, it will
go to sleep, press any button to wake it back up.
Press the button to start cleaning. Once started, the
robot leaves charging dock. The robot will plan its
cleaning route based on its scan of the area. It cleans
along a zone first and then move Zig - zag cleaning route
A. Cleaning mode
Press the button to start cleaning. Once started, the
robot will plan its cleaning route and map based on its scan
of the area After cleaning, the robot will return to the
charging dock automatically.
B. Spot Cleaning (Only remote control support )
After starting the spot cleaning mode, this mode is used to
clean a 1.5m x 1.5m square area centered and it is in zig-zag
cleaning mode on the map. After cleanup, the robot will
return to the center of the square. Use the app to set a
destination for the robot to go to.
Cleaning cannot start if the battery level is too low. Allow the robot to
charge before restarting cleanup.
Tidy away any cables on the ground ( including the power cable of the
charging dock ) before cleaning to avoid losing power or damaging
either the robot or the connected device.
1.
2.
NOTE:
