Gecko SSPA-1-AS SPA PACK, Quick Reference Card

Page: 1 / 2

SSPA-1-AS SPA PACK
•
Dual-Pump (or Single-Pump & Blower) System
•
Quick Reference Card
This Quick Reference Card is a summary of your spa's main functions
and provides a quick overview of operations accessible from your spa side keypad.
Press the Pump 1 key to turn the pump on
at low speed. A second press will turn the
pump to high speed. A third press will turn
the pump off. A built-in timer will shut the
pump off after 20 minutes unless it has
been manually deactivated.
The "Pump 1" marker will be
displayed when the pump is running.
To start the pump:
Press the Pump 2 key to turn the blower
on. A second press will turn the blower off.
A built-in timer will shut the blower off after
20 minutes unless it has been manually
deactivated.
The "Pump 2" marker will be displayed
when the blower is running.
Note: For single-pump & blower configuration only.
To start the blower:
Press the Light key to turn the light on. A
second press will turn the light off. A built-in
timer will shut the light off after 2 hours
unless it has been manually deactivated.
The "Light" marker will be displayed
when the light is on.
To turn the light on:
When the water temperature is 0.5˚C
(1˚F) lower than the set point, the heater
will be turned on until the water tempera-
ture reaches the set point plus 0.5˚C (1˚F).
The "Heater" marker will be displayed
when the heater is on.
It will flash
when there is a call for heat but the
heater has not started yet.
Note: If your system is configured in Low Current
Mode, the heater will not start if the pump is
running at high speed.
Water heater automatic start:
Press the Up/Down arrow key to increase
or decrease the desired water temperature.
The selected temperature setting ("set point"
value) will be displayed for 5 seconds as a
confirmation.
The "Set Point" marker on the display
will indicate that the temperature
shown is the desired, and not the
current temperature of the water!
The temperature can be adjusted by 1˚
increments from 15 to 40˚C (59 to 104˚F).
To change the water temperature:
Temperature display unit:
The water temperature can be displayed
in ˚C or ˚F. Simply press and hold the
Light key for 10 seconds to toggle between
˚C or ˚F.
Press the Pump 2 key to turn pump 2 on.
A second press will turn the pump off. A
built-in timer will shut the pump off after
20 minutes unless it has been manually
deactivated.
The "Pump 2" marker will be
displayed when the pump is running.
Note: For dual-pump configuration only.
To start pump 2: