INSTALLATION
WARNINGS
(MAY CAUSE SERIOUS INJURIES OR DEATH)
•
The power supply must be turned off during the installation process.
•
This pump is wired for 115 VAC, 60 Hz, and Single Phase power
supply only. The power supply should be supplied through a Ground
Fault Circuit Interrupter (GFCI) with a rated tripping current not
exceeding 5 mA.
•
No part of the pump is to be located above the jetted bath during
use. Parts incorporating electrical components, except remote
control devices, must be located or fixed so that they cannot fall into
the jetted bath.
•
Pump and other parts containing energized or live parts, except parts
supplied with safety extra low voltage not exceeding 12 V, must be
INACCESSIBLE to a person in the jetted bath.
•
Pump must be mounted INDOORS on top of a horizontal and solid
surface; fixed securely using screws or bolts through the 4 mounting
holes located on the base.
•
This pump is not intended for use by young children or infirm
persons without supervision.
•
Young children should be supervised to ensure that they do not play
with the unit.
CAUTION
(MAY CAUSE PROPERTY DAMAGE
)
•
This pump is intended for
Jetted Bath use ONLY,
and is not
suitable for any other application.
•
DO NOT run the pump without water. This
may damage pump and
its components.
1. Be sure that the requirements under Mounting Preparation section
have been met.
2. The pump is provided with barrel unions to connect the pump’s
Suction port (inlet) and Discharge port (outlet) to the plumbing. The
plumbing must be routed or oriented in a way that when the pump is
installed, the port connections are not subjected to undue stress.
Summary of Contents for Aqua-Flo Therma-Flo Enviro-Heat Series
Page 1: ......