11
3.3. Cable mounting
For the choice of cable, chart 1 must be consulted.
The cable must run-off upwards from behind the drum.
The cable is allowed to run-off backwards horizontally from underneath the drum with the WW series as well as
with some of the models in the VL series.
Be careful!
The brake does not work in the case of an incorrect cable run-
off.
The cable length must be of sufficient length to allow for 3
windings to remain on the drum when in the lowest position.
The cable is mounted by means of the fixed cable clamp.
3.4. Before use
The winch is fitted with a worm wheel gearing. To ensure a long lifespan we
recommend that the winch be run in before use.
Allow the winch to make approx. 5 drum rotations whilst loaded with approx. 50%
of the nominal load. Remove the protection cover and using a brush, redistribute
the grease over the worm wheel and the worm gear. Replace the protection
cover. The winch is now ready for use.
Check before each use if the transfer is sufficiently greased. This will
prevent "galling" and overheating.
To enable the load pressure brake to function correctly, the winch must carry a
minimum load of approx. 5% of the nominal load.
3.5. Operating
The winches are suitable for manual operation only.
For the load to be hoisted, turn the crank clockwise.
For the load to be lowered, turn the crank anticlockwise.
4. Maintenance
The winch must be unloaded for inspection and maintenance tasks.
Inspection and maintenance tasks must be performed by skilled personnel, e.g. via your Gebuwin
dealer.
