Geberit 115.817.11.5, Maintenance Manual

Page: 5 / 24

EN
5
D64372-001 © 12-2013
966.444.00.0 (00)
Operation
Settings using the Geberit Service Handy
The infrared interface for communication with the Geberit Service Handy is located in the middle of the
cover plate. To make any settings, the Geberit Service Handy must be aimed at this area from a distance of
20 to 30 cm.
Figure 1: Operation using the Geberit Service Handy
The numbers and terms in the column "Menu item" correspond to what can be seen on the display of the
Geberit Service Handy. Further information can be found in the user manual of the Geberit Service Handy.
Information given in [ ] corresponds to the text displayed on the Geberit Service Handy display.
Information given in < > refers to buttons on the Geberit Service Handy.
Table 2: Commands
In order to be able to make settings, the Geberit Service Handy must be set to bidirectional mode.
Once bidirectional mode has been set, the Geberit Service Handy must be aimed at the infrared
interface within seven seconds to establish communication with the control.
Menu item
[EN]
[DE] Description Application Adjustment
range Factory
setting
20
[Flush]
[Spülung] Release flush.
Actuates a flush • To run a function test
on the valve
• To flush out the urinal
ceramic (e.g. when
setting the optimum
flush volume)
Start = <OK> –
21
[RangeTest]
[TestErfas] Check detection range.
The red LED in the sensor window
starts to light up when an object
enters the detection range. No flush
is actuated in this process.
The function is deactivated
automatically after ten minutes For problems with user
detection On = <OK>
Off = <OK> Off = [OFF]
20 20–30 cm 30 cm 20–30 cm