Ge BE E + F Gm bH • ww w .oe m- pri nte r .co m • Ge BE Do k.N r .: SM AN -E- 413 -V3 .0 Eas y-L oad ing The rm al Pri nte r GPT -43 52
In st al la tio n
5
4 In st al la tio n
4.1 Installation in a fr ont panel
The plastic housing of the GPT -4352 printer can
be installed with two scr ews in an easily done
cut-out of a fr ont panel with up to 4 mm thick-
ness. The contact surface is flat. The edge of the
housing juts out by 1 mm, covering the space
between the panel and the housing.
The housing is pushed into the cut-out fr om the
outside, and then easily scr ewed on.
The two holes of 2.8 mm diameter allow the use
of M 2.5 scr ews.
4.2 Partial installation in plastic casing
As shown in the pictur e, the printer housing can also be in-
stalled at the edge of a casing. This installation variant has
the part of the printer housing that contains the paper r oll
extending beyond the unit casing. This saves r oom in the
device casing for the installation of other components.
T o facilitate installation in dif fer ent casing shapes, the outer
wall of the paper storage was left smooth below the bearing
collar . The housing can pr oject about 19 mm fr om the casing
edge, since about half of the paper storage can be used,
right up to the slanting slot for inserting the mounting plate.
4.3 Einbaubeispiele und Anwendungen
As the pictur es show , the installation types ar e almost
unlimited. The advantage of the complete thermal printer
Mini Mulde in its plastic housing consists above all of the
fact that it becomes possible to use the practical
Easyloading technology of the printer mechanisms also in
applications with smaller numbers of items.
For this small GeBE-printer a paper r ewinder is available, so
that also a printer with pr esentation stage, like shown above,
can be used e.g. in a contr ol panel housing. The Mini
MULDE is used also in the Desktop Printer Series POCKET
and is suitable for Handheld computers with printing station.
Application in a pocket printer GPT -4333
with infrar ed interface