Layout and Functions
8
GeBE E + F GmbH • www.gebe.net • GeBE Doc. No.: SMAN-E-673-V1.2 • Desktop Ticket Printer GPT-4633
4.3 Paper exit
4.3.1 Cutter
After printing, the paper/ticket will be cut and fad out of
the device. The paper can be completely cut by
using the full cut command or partial cut by segment
cut command. The command is either programmed in
the driver software or can also be given directly.
4.3.2 Output lip
The printer exits paper the through the output lip, as
shown in picture below. After a full cut the ticket/paper
falls down. After a segment cut the ticket lolls out of
the output lip and can be ripped off.
4.3.3 Paper exit ramp
(on request)
After a full cut, the ticket can be held in a paper exit
ramp (optional). The ramp will be fixed onto the output
lip.
4.3.4 Output bezel
Alternatively, after a full cut the ticket can be held by the
printer through the use of an optional output bezel (11).
The output bezel will be installed onto the output lip.
Therefore the printer has to be opened as described
under section 4.2.6.
11
Slide the output bezel onto the profile and close the
printer housing.
