Gearmore 2G2 Series, Operation, Service & Parts Manual

Page: 5 / 14


CUTTING EDGES
- are reversible so
always remember to " fl ip" them over
before wearing the back plate. Replace the
cutting edge after both edges are worn to
the bottom edge of the back plate.

2 POSITION SHANKS
- have a
shallow or deep setting. When changing
positions, make sure the shank retainer is
"seated" properly in the beam. We have a
special fl at bottom retainer that should
always stay in place if installed properly.

REPLACEABLE SHANK POINT
-
make sure you replace the point before
you wear the drop forged shank. Knock
off the worn point and lock the new point
in place by "crimping" at the recessed
holes in the shank.

PREVENTING DAMAGE
- to your
scraper is directly proportional to the
speed you are operating at when you hit
an immovable object . Please try to
operate at slower speeds when working in
unknown conditions.
GENERAL INFORMATION
3