INSTALLATION (Continued)
Page 10
4.
Tack weld the positioned brackets to the bucket. Roll the bucket forward to check
alignment. Then roll back into working position to make sure the rod "bottoms out"
in all brackets.
NOTE:
If the forks extend more than 8" below the bucket, it will be necessary
to order new rod bushings to weld on the forks in a lower position.
5.
Complete the welding of the brackets to the bucket. The weld should cover the full length
and both sides of the bracket.
The side of the fillet weld should be:
⇒
3
/
8
" thick brackets -
1
/
4
" fillet weld
⇒
1
/
2
" &
3
/
4
" thick brackets -
3
/
8
" fillet weld
6.
Install the rod locking collar on the open rod end.
