End Brace
Post
Positions
End Brace
Handle
6
C
ART TO
T
ABLE
C
ONFIGURATION
It is best to use 2 people when converting the Gearboss TranSPORT cart to the Table configuration.
To put the cart in the Table configuration, do the following:
1.
Rotate the pull handle under the cart deck.
2.
Lift the End Braces and rotate them down to the ground.
3.
Grip side of cart near one end and lift (2 people), allowing the End Brace to rotate into the “leg” position.
4.
Grip side of cart near opposite end and lift until the End Brace rotates into positon.
5.
The slots in the End Brace should engage with the Posts.
T
ABLE
U
SAGE
If the Gearboss TranSPORT cart is being used in the Table configuration, make sure that the following
conditions exist:
•
Do not exceed 1000 lbs of weight on table
•
Distribute weight evenly on table
•
Never try to move a loaded table
•
Use caution on rough or soft ground
•
Do not use Table configuration on steep inclines.
Keep hands clear of the end
braces when they are in
motion. Gripping the cart in
the wrong place could result
in injury to hands or fingers.
!
CAUTION
Never try to move a loaded
table. Lifting the table may
release the end braces
suddenly, causing an upset
and resulting in injury or
damage to equipment.
Always remove items from
the table, convert it back to a
cart (using two people ) and
move it to it’s new location.
!
CAUTION
Never exceed 1000 lbs of
weight on the table. Be sure
that weight is evenly
distributed. Severe injury or
damage to the cart may
result.
!
CAUTION
Use caution on rough or soft
ground. Do not use Table
configuration on inclines.
Severe injury or damage to
the cart may result.
!
CAUTION
