Screw the nuts in place on the Volume and Tone Pots and the Jack Input to keep
them in place. Place the Tone Selector Plate (7) over the top of the Tone Selector (4)
and then screw the nut and washer on top. Screw the Scratch Plate (11) in place
using 5 of the 13mm screws. At this point the Bridge Pins (17) and Tailpiece Pins (18)
should be put in place (as pictured). The earth wire (black) should be threaded
through the hole from the body cavity to the tailpiece hole, and soldered to the first
Bridge Pin (18)
Step 5
