WARNING
:
To avoid eye injury, do not stare directly into the light beam or shine the
beam directly into anyone’s eyes. This product is not designed, intended, or
recommended for children or hazardous environments.
CAUTION:
The flashlight may become warm or hot after extended periods of use
at the highest setting. Select a lower setting when the flashlight is hot. This is
typical for high-powered flashlights and does not cause damage to the flashlight.
AA Battery Installation
1. Unfasten tail cap and remove battery holder.
2. Insert 4 AA batteries following the correct polarity (+,-) marked on the
battery holder.
3. Insert the battery holder back into the flashlight with the positive (+) end first.
On/Off
Zoom
1. Hold both ends of the flashlight; gently twist and pull each end away from the
other.
2. Pull the two ends away from each other to zoom in and push the two ends
together to zoom out.
To turn the flashlight on, press down firmly on the red power button located
on the tail of the flashlight until you hear a click.
To turn the flashlight off, press down firmly again until you hear a click.
Switching Modes
There are 5 different lighting modes. (High, Medium, Low, Strobe, SOS)
To switch through the different lighting modes, gently press down on the red
power button to alternate through the 5 modes.
The flashlight will switch to the next mode when turned off and on in quick
succession. It will reset back to the highest mode after being off for more than
10 seconds.
GETTING STARTED
OPERATION
WARNING:
Always follow the battery manufacturer’s instructions as to the proper
usage, handling, storage, and disposal of batteries. Use only batteries from a
reputable manufacturer. Do not mix different brands or types of batteries in the same
flashlight. Replace all batteries at the same time. Immediately remove batteries from
a defective flashlight. Failure to follow safety instructions may result in personal injury
and damage to property.
ZOOMABLE
DESIGN
ANTISLIP
BODY
RUBBER
O-RING
AA BATTERY
HOLDER
TAIL
CAP
