GEA T.VIS A-15, Operating Instructions Manual

Page: 32 / 116

Technical data: non-cyclical data exchange
Sub-
index
Offset Function
Access
rights
Range Default Signal
0x0B 0x0A Device ID 2 R/W 0x00 - 0xFF 0x34
0x0C 0x0B Device ID 3 R/W 0x00 - 0xFF 0x56
Index 0x01 - Parameter
0x01 0x00 Colou Selection R/W 0x00 - 0x01 0x01
0= yellow
1= green
0x02 0x01 Tolerance R/W 0x00 - 0x04 0x02
0= 2.0mm
1= 1.0mm
2= 0.7mm
3= 0.3mm
0x03 0x02 Signal Damping R/W 0x00 - 0x04 0x03
0= 1.0 sec.
1= 0.5 sec.
2= 0.1 sec.
3= OFF
0x04 0x03 LEFF R/W 0x00 - 0x04 0x02
0= OFF
1= VT-Lift
2= DT-Lift
3= VT + DT-Lift
0x05
0x06 0x04
0x05 Not-Activated
Position
M
0x00 - 0x04
0x00 - 0xFF 0 … 1023 (10Bit)
0 … 78mm
0x07
0x08 0x06
0x07
Activated Position M
0x00 - 0x04
0x00 - 0xFF 0 … 1023 (10Bit)
0 … 78mm
0x09
0x0A 0x08
0x09
Lift Position M
0x00 - 0x04
0x00 - 0xFF 0 … 1023 (10Bit)
0 … 78mm
Where access to the entire record of an index takes place, the offset within
the record applies (table above).
On account of the setup of the T.VIS necessary for commissioning and
following seal changeover, we have refrained from implementing data
retention!
5.5 Specifications for AS-interface
Technical data: supply
Designation Description
Supply voltage UV 26.5...31 V DC
Current consumption
- No-load current
≤ 25 mA
- One solenoid valve 35...45 mA
Total approx. 90 mA
Software version A and B (see version labels AASi / BASi)
Technical data
Specifications for AS-interface
430BAL010699EN_6
32 17.03.2022