![background image](http://html.mh-extra.com/html/ge/zoneline-3000-series/zoneline-3000-series_use-and-care-manual_2198499003.webp)
the
-COOLER
THERMOSTAT
1 2 3 4 5 6 7 8 9
10 11 12
A
FAN ONLY
Thermostat Control
Lights when the
Ventilation control
set at
Lights when the air
HEAT
conditioner is
operating in the
cooling mode.
The Thermostat Control has
numbered settings plus a FAN
ONLY position.
Slide the Thermostat Switch
to the lower numbers for cooler
temperatures, to the higher numbers
for warmer temperatures.
For fan only operation, without the
compressor or heater, slide the
Thermostat Switch the way to the
right to the FAN ONLY position.
Sentinel
Whenever room air temperature
at the air conditioner falls to
approximately
the unit will
automatically come on in the
heating mode.
ON/STOP
OPERATION
PUSH
COOL HEAT
LOW,
Master
Push
Operation Button once to
turn the air conditioner on; push
again to turn it off.
If the unit does not operate when
you push this button to start it,
check to see if the Unit Power
Switch located behind the room
cabinet is on. See page 4.*
Slide the Selector Switch to COOL
for cooling, or to HEAT for
heating.
Slide the Fan Speed Switch to
LOW for cooling or heating with
low fan speed operation.
it to
HIGH for cooling or heating with
high fan speed operation.
*Not
e:
setting controls,
a 3-minute delay before the
compressor starts is normal.
Air
I
II
For best heat distribution,
tilt the
louvers down so the heated air is
directed across the room.
For best distribution of cold air,
tilt the louvers up so the cold air is
directed towards the ceiling.
3
1
For
heating and cooling
certification, the air louvers are
tilted straight out as shown above
(30 degrees from the vertical axis).